Параметри на производот

Item Type:

Spot Welder

Material:

ABS, PCB, Brass, Silicone

Battery:

Lithium battery 3.7V 5300mAh (with built in battery)

Purpose:

Suitable for repair, home DIY and other welding needs

Basic Parameters:

Gear:

1 to 6

Welding Thickness:

0.1 to 0.15mm

How to Use:

1. Press and hold the switch for 2 seconds to open and close.:

2. Briefly press to switch gears (gears 1 to 6 are optional).:

3. Under the power on state, the green LED flashes several times to indicate the gear position.:

4. The green light flashes when charging and always lights up when fully charged.:

Package List:

1 x Spot Welder:

1 x Nickel Sheet:

1 x USB Cable:

Note:

1. After the user gets the product, the battery is generally not fully charged. Please fully charge it before using it to obtain the best effect.:

2. This machine can weld 0.1 to 0.15mm nickel steel sheet and 0.1 pure nickel sheet. Pure copper and other materials with good conductivity cannot be welded.:

3. If it is not used for a long time, the battery power should not be too low or too high.:

4. If the power is too low, it will cause the single chip computer to not work, which means that the machine cannot be turned on and the charging lamp will not be on. In this case, please charge it, and it can be recovered after charging for dozens of minutes.:

5. Current, voltage and material can affect the spot welding effect. Not all materials can achieve good spot welding effect. Now the spot welding time and contact strength can be adjusted. It is recommended to use iron cans to practice first, and then weld electricity after getting familiar with the welding machine.: